|
|
|
Kto jest w sklepie?
Sklep przegląda 6043 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Note : Make these 2 adjustments (3-S1, 3-S2) after perfoming section 3-13. 3-S1. W/B plunge correction adjustment S1-1. Adjustment of NTSC composite 1) Input the 525 all white (with burst) cut-off signal. 2) Adjust the brightness to a value below 10 cd/m2 with CONT and BRT VR. Brightness adjustment:3 cd/m2 3) Turn CHROMA VR to MIN, and measure the color temperature. 4) Turn CHROMA VR to MAX, and make adjustment with
NTSC B-Y
S1-4. Adjustment of DIGITAL 1) Input the DI 525 all white cut-off signal. 2) Repeat the operations S1-1. 2) and 3). 3) Turn CHROMA VR to MAX, and make adjustment with DIGITAL R-Y and DIGITAL B-Y so that the color temperature will be the same as the value measured in item 2). Standard adjustment: The difference should be within 2 JND when CHROMA MIN n MAX. S1-5. Adjustment of NTSC443 composite 1) Input the all white (with burst) cut-off signal. 2) Repeat the operations S1-1. 2) and 3). 3) Turn CHROMA VR to MAX, and make adjustment with NTSC443 R-Y and NTSC443 B-Y so that the color temperature will be same as the value measured in item 2). Standard adjustment: The difference should be within 2 JND when CHROMA MIN n MAX.
and
NTSC R-Y
so that the color temperature will
be the same as the value measured in item 3). Standard adjustment: The difference should be within 2 JND when CHROMA MIN n MAX. S1-2. Adjustment of PAL composite 1) Input the 625 all white (with burst) cut-off signal. 2) Repeat the operations S1-1. 2) and 3). 3) Turn CHROMA VR to MAX, and make adjustment with PAL B-Y and PAL R-Y so that the color temperature will be the same as the value measured in item 2). Standard adjustment: The difference should be within 2 JND when CHROMA MIN n MAX. S1-3. Adjustment of COMPONENT 1) Input the 525 all white cut-off signal to Y. Note : NTSC all white (with burst) may be input. 2) Repeat the opelations S1-1. 2) and 3). 3) Turn CHROMA VR to MAX, and make adjustment with COMPONENT B-Y and COMPONENT R-Y so that the color temperature will be the same as the value measured in item 2). Standard adjustment: The difference should be within 2 JND when CHROMA MIN n MAX.
�5�
|
|
|
> |
|
