Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
ASSEMBLY
Fitting the bevel gear
� Guide the guard B onto the shaft so that the hole in the guard aligns with the hole in the bracket. Tighten the screws C.
�
Assembling the angle gear on the shaft. Turn the shaft so that the splines on the drive axle mate in the angle gear.
B
4xC
�
Align the bracket with guard so that it sits straight in relation to the tines.
�
First tighten the screw H and then the screw M.
M
�
Tighten the screws F.
H
Assembling the guard.
� Remove the four screws C and the two screws F from the bracket A.
F
A C
�
Place the rubber sleeve D on the shaft E. The rubber sleeve should sit between the arrow markings on the shaft.
E
D
�
Place the bracket A around the rubber sleeve and �t the screws F loosely.
F A
