Dla tego produktu nie napisano jeszcze recenzji!
Power supply
OPE / BATT
Connections
IMPORTANT
� Make sure that the AC cord is disconnected and batteries are removed before connecting speakers. � Do not connect other than the supplied speakers.
1
The OPE/BATT indicator lights up while the power is on.
Position the speakers.
To couple with the speakers, slide each speaker down into the guide brackets on the center unit until the height is level with the unit. To separate the unit from the speakers, slide the speakers up and off, while pressing the speaker release knob.
Using on AC house current
Connect the AC cord as illustrated below.
to the AC inlet of the unit supplied AC cord to an AC outlet (AC 120 V, 60 Hz)
CAUTION
Use only the supplied AC cord. Use with other cords may result in the risk of fire.
Release knob
2
Connect the speakers.
Connect the right speaker cord to the R terminals, and the left speaker to the L terminals. Connect the speaker cord with the white broken line to 0 and the other cord to 9.
Using on batteries
Open the lid of the battery compartment on the rear and insert eight R20 (size D) batteries, not supplied, as illustrated below. Then close the lid. To switch from AC power supply to battery supply, disconnect the AC cord from the AC inlet.
R20 (D)
When the OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, or sound is distorted during operation, replace the batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe the following: � Insert the batteries with the 0 and 9 marks correctly aligned. � Do not mix different types of batteries or old batteries with new ones. � When the unit is not to be used for a long period, remove the batteries. � Never recharge the batteries, apply heat to them or take them apart. � Remove dead batteries. If liquid leaks from the batteries, wipe thoroughly to remove.
4
ENGLISH
|