JVC CAMXJ150
Instrukcja Obsługi

English

Listening to FM and AM (MW/LW) Broadcasts
Tuning in a Station

1 Tune in the station you want to preset.
� See �Tuning in a Station� to the left.

1 Press FM/AM.
The unit automatically turns on and tunes in FM/AM the previously tuned station (FM, MW, or LW). � Each time you press the button, the band changes among FM, MW, and LW.

MHz

2 Press PROGRAM/SET.
PROGRAM/SET

2 Select a station.
On the unit: Press and hold TUNING � or TUNING + for more than 1 second.
- TUNING TUNING +

PRGM

The PRGM flashes on the display.

3 Press PRESET � or + to
TUNING MODE

On the remote control: 1) Press TUNING MODE so that �MANUAL� appears on the display. 2) Press and hold 4¥1 or ¢¥¡ for more than 1 second.

select a preset number.
�
PRESET

+

PRGM

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the ST (stereo) indicator lights up. To stop during searching, press TUNING � or TUNING + (or 4¥1 or ¢¥¡ on the remote control).
When you press TUNING � or TUNING + (or 4¥1 or ¢¥¡ on the remote control) briefly and repeatedly The frequency changes step by step.

4 Press PROGRAM/SET again.
The tuned station in step 1 is stored in the preset number selected in step 3. � Storing a new station on a used number erases the previously stored one.

PROGRAM/SET

When you unplug the AC power cord or if a power failure occurs The preset stations will be erased in a few days. If this happens, preset the stations again.

Tuning in a Preset Station

To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, press FM MODE on the remote control so FM MODE that the MONO indicator lights up on the display. Reception improves. To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo. The FM reception mode is restored even when the unit is turned off.

1 Press FM/AM.
The unit automatically turns on and tunes in the previously tuned station (FM, MW, or LW). � Each time you press the button, the band changes among FM, MW, and LW.
FM/AM

2 Select a preset number.
On the unit: Press PRESET � or +.
�
PRESET

+

Presetting Stations
You can preset 30 FM, 8 MW, and 7 LW stations. In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the remote control: 1) Press TUNING MODE so that �PRESET� appears on the display. 2) Press 4¥1 or ¢¥¡.

TUNING MODE

� 11 �