Connecting Speakers
You can connect a pair of the front speakers.
1
2
3
1
Vinyl-covered wire (not supplied)
ANTENNA
FM 75
COAXIAL
2
3
CAUTION: SPEAKER IMPEDANCE 6~16 OHMS.
Red Speaker cord
SPEAKERS
AM EXT AM LOOP
Speaker cord
GND
RIGHT
LEFT
Black
AM (MW/LW) loop antenna (supplied)
1 Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
Right speaker
Left speaker
2 Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM (MW/LW) loop antenna must remain connected.)
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
For better reception of both FM and AM (MW/LW) � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
