jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 107 (kliknij aby zobaczyć)
5
6
7
8
7.4 SETTING THE ID NUMBER AND COPYING THE ID DATA
The ID number is stored in the flash memory on the DVDM Assy and the EEPROM on the AJKB Assy. The ID data are stored in the EEPROM on the AJKB Assy. When these Assys are replaced, setting of the ID number and copying of the ID data may be required, as indicated below: (1) When only the DVDM Assy is replaced: Setting of the ID number and copying of the ID data are not required. Copying of the ID number is automatically performed from the EEPROM on the AJKB Assy to the flash memory on the DVDM Assy. (2) When only the AJKB Assy is replaced: Copying of the ID data is required. Copying of the ID number is automatically performed from the flash memory on the DVDM Assy to the EEPROM on the AJKB Assy. (3) When both the DVDM and AJKB Assys are replaced: Both setting of the ID number and copying of the ID data are required. (ID data disc to be used: GGV1174)
A
How to enter the ID number and copy the ID data
1 Press the ESC then STEREO keys to enter Input mode.
B
2 Enter a 9-digit ID number (it is also displayed on the LCD). The ID number is indicated on the label attached on the rear panel.
5 While data are being read, the indication shown below will be displayed. ("RD ID DATA" is displayed on the LCD.)
2
C
5
3 Press the SEARCH key to registrer the entered ID number.
6 The data will be written in the EEPROM after reading of the ID data is finished. ("WR ID DATA" is displayed on the LCD.)
D
6 3
4 After the ID number is set, the unit is ready for ID data input. ("IN ID DATA" is displayed on the LCD.) Install the ID data disc in the disc tray and press the Close key on the main unit. Data will be read from the disc.
7 After writing of the data to the EEPROM is finished, "Rom Write OK!" will be displayed. ("ID DATA OK" is displayed on the LCD.) 8 After confirming the above indications, press the CLEAR key to terminate Setting mode.
