|
|
|
Kto jest w sklepie?
Sklep przegląda 5718 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
5 � Recording CDs�Advanced recording
If the �noise floor� is higher than the threshold, synchronized recording will not take place (but remember that synchronized recording is not recommended with the PHONO mode � see �Recording to disc from the RIAA PHONO inputs� on page 27):
level Start of track is not registered Noise is higher than threshold
S_LVL
Alternatively, when recording digitally from sources (MD, CD and DAT) which output track divisions, synchronized recording starts when a track division is received, regardless of the level:
Track signal from source starts recording
level
S_LVL
time
time
To stop synchronized recording: 1 2 The unit must be in record mode, and the SYNC indicator in the display must be lit. Stop the source. After a few seconds, the unit enters record ready mode. The time between the stopping of the source and entering record ready mode is used to record a gap at the end of the track. If no changes are made to the unit�s controls, restarting the source restarts recording, as the unit is still in sync mode and will start recording again when the source is detected.
Because synchronized recording can be turned on and off while recording is taking place, it is therefore possible to record with a synchronized automatic start, and a manual end, or vice versa. When the source material is being played back before synchronized recording is enabled, the conditions under which synchronized recording will start (after synchronized recording has been enabled) are: When the signal drops below the threshold for one second or more and then rises above the threshold again (this is the general condition, of which starting synchronized recording from a stopped or paused source is a special case):
At least 1 second Recording starts
3
NOTE
level
When recording in sync mode, you may notice a slight delay between starting the source, and the CC-222 responding. This is due to the way in which the unit works, storing the data in a memory buffer before writing it to the disc. The resulting delay is therefore not a cause for concern�all audio data received between the start and end points will be recorded.
S_LVL
time
Synchronized recording
Synchronized recording means that recording will begin automatically when a signal is received, and will stop when the signal ends. To enable or disable synchronized recording: 1 A recordable disc must be loaded. 2 With the unit in record ready or record mode, press the SYNC REC key. The display shows SYNC ON briefly, and then changes to the track and time display. When synchronized recording is enabled, the SYNC indicator lights in the display. The SYNC REC key is also used to turn off synchronized recording (the display briefly shows SYNC OFF and then returns to the track and time display).
30 TASCAM CC-222 Owner�s Manual
|
|
|
> |
|
