Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 52 (kliknij aby zobaczyć)
52 FM Radio
Follow the steps below to listen to FM radio stations through the TV/VCR.
1
Press the FM button to select FM mode. The radio frequency appears on the TV/VCR screen, moving around the screen every few seconds.
FM 88.0MHz
Choosing FM stations...
EJECT POWER MENU STATUS/EXIT CLEAR
1 4 7
SLEEP/ WAKE UP
2 5 8
PLAY REW STOP
3 6 9
ALT.CH
0
2
Press the CH(annel) o//p buttons until your desired radio frequency appears. You can choose FM stations within the band range of 88.0 ~ 108.0 MHz. You may get better FM reception by repositioning the TV/VCR.
REC /OTR
PAUSE /STILL
F.FWD
3
2
CH.
To exit FM mode and return to TV mode, press the FM button again.
1,3
FM
VOL. MUTE
SPEED
F.ADV
TRACKING
MEMORY
SLOW
Switching the Antennas
If you receive a weak radio signal, you may go to TV mode and switch between the internal (INT) and external (EXT) antennas. When you select the external antenna, make sure your TV antenna or TV cable signal is connected to the ANT(enna) Jack on the TV/VCR. Details are on page six. To switch the antennas, follow these steps.
1 2 3 4
Press the FM button to return to TV mode if necessary.
Press the MENU button.
Helpful Hints
� If you turn off the TV/VCR in FM mode, the TV/VCR will be in TV mode when you turn on the TV/VCR again. � You cannot record the FM station. � You cannot switch to FM mode during tape playback, although tape playback is allowed while in FM mode. � You must be in TV mode in order to select Line Input mode (A/V IN).
Press the PLAY/v button or the STOP/w button to select FM ANTENNA.
Press the REW(ind)/{ button or the F.FWD/B button to select INT or EXT.