Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
CD-E250E
System connections (continued)
! To mount the surround speakers on the wall
The design of the surround speakers allows them to be hung on the wall. Be sure to use the type and size of screw that is shown to the right.
Min. 22 mm (7/8") 9 mm (3/8") 3.2 mm (1/8") 5 mm (3/16")
! Connecting the AC power lead
After checking all the connections have been made correctly, connect the AC power lead to the AC power input socket, then plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the demonstration mode. Notes: " Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time. " Never use a power lead other than the one supplied. Otherwise, a malfunction or an accident may occur.
1
Make a hole in the wall using a drill.
! Demonstration mode
32 mm (1-1/4") 8-9 mm (3/8")
The first time the unit is plugged in, the unit will enter the demonstration mode. You will see words scroll. To cancel the demonstration mode: When the unit is in the power stand-by mode (demonstration mode), press the X-BASS/DEMO button. The demonstration mode will be cancelled and the display will disappear. To return to the demonstration mode: When the unit is in the power stand-by mode, press the X-BASS/ DEMO button again. Note: When the power is on, the X-BASS/DEMO button can be used to select the extra bass mode.
2
Preparation for Use
Drive a wall mount plug into the hole using a hammer. Drive the wall mount plug in until it is flush with the wall surface. Drive one screw into the wall mount plug for each speaker. Drive the screws, so there is about a 5 mm (3/16") space between the wall and the head of the screw. Mount the surround speaker on the wall so that the screw head is inserted into the slot on the surround speaker.
Wall surface
3
Wall surface
Wall mounting screw
4
! To turn the power on
Press the ON/STAND-BY button to turn the power on. After use: Press the ON/STAND-BY button to enter the power stand-by mode.
Caution: The speaker may fall if mounted improperly. Check the stability of the wall thoroughly. Sharp is not liable for accidents caused by poor wall stability or improper mounting.