Recording From CDs
Creating your own program (continued)
Recording a CD by Specifying Tape Length (Time Edit)
You can have the player create a program that will fit the length of the tape. The player automatically creates a program, keeping the original order of the disc. The program can contain up to 32 steps (a pause inserted between steps is counted as one step). Note that tracks numbered over 20 cannot be programmed automatically.
Changing the track order
You can change your program before you start playing.
To You need to
Erase a track
Press CHECK until the track you don�t want appears in the display, then press CLEAR.
Erase the last track Press CLEAR. Each time you in the program press the button, the last track will be cleared. Add tracks to the end of the program Follow Steps 2 through 4 of the programming procedure.
Change the whole Hold down CLEAR until program �CLEAR� appears in the display. completely Create a new program following the programming procedure.
1 Press DISC SKIP to select the disc. 2 Press TIME EDIT repeatedly before you
start playing until �EDIT� appears and �A� in the display. length. indication flashes in the
Fading In or Out
You can manually fade in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector.
To Press FADER
3 Press m or M to specify the tape
Each time you press these buttons, the display changes as shown below, with the tape length of one side following each indication.
C-46 23.00 - -. - C-54 27.00 C-90 45.00 C-60 30.00 C-74 37.00
Start play fading in During pause. �FADE� flashes. The play fades in. End play fading out When you want to start fading out. �FADE� flashes. Then play fades out and the player pauses.
4 Press TIME EDIT to have the player
create the program.
Fading time lasts for 5 seconds.
The display shows the tracks to be recorded. �B� in the indication flashes in the display.
5 When you record on both sides of the
tape, press TIME EDIT again.
The player inserts a pause, then creates the program for side B. The display shows the programmed tracks. When you record on one side of the tape, skip this step.
