2 � Features of the CD-RW750
Use of the remote control unit
When using the RC-RW750 remote control unit, make sure: � There is a clear unobstructed path between the remote control unit and the remote sensor 7 on the main unit. � The remote control unit is located within 5 m (15 ft.) of the main unit, and is pointing at approximately right angles (±30°) to the front panel. When fitting or replacing the batteries: � Always make sure that both batteries are replaced together. Do not mix old and new batteries. � Do not mix batteries of different types. � Always make sure that the batteries are located with the correct polarity (the positive terminals of the batteries should match the + markings inside the battery compartment, and the negative terminals should match the � markings). � If you are not going to use the remote control unit for an extended period of time, remove the batteries. Old batteries can leak, casing damage to the remote control unit. � Always dispose of old batteries in the way recommended by your local garbage disposal authorities.
Connections
The following should be noted when you connect the unit to other equipment. It is possible to connect the unit�s DIGITAL other equipment at the same time. However, the unit can receive signals from only one digital input at a time. Audio signals output from the unit are output from the analog ANALOG OUT O jacks, as well as from the DIGITAL COAXIAL OUT jack P and DIGITAL OPTICAL OUT connector Q simultaneously (but not from the digital outputs in stop mode).
COAXIAL IN P and DIGITAL OPTICAL IN Q to
Using the timer function
You can set the CD-RW750 to start playback when it is switched on (for example, from an external timer). To do this, slide the TIMER switch C to the PLAY position. When the unit is turned on it will start playing from the start of the loaded disc.
