jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
Tekstowy podgląd strony 21 (kliknij aby zobaczyć)
4-2. CIRCUIT BOARDS LOCATION
� Waveforms
(MODE:PLAY)
1
0V
DISC IN SW board
SUB board
Approx. 620mVp-p
tuner unit LIMIT SW board
IC2
1
(FEO)
2
1.2Vp-p
IC2
#¡
(RFO)
3
0V Approx. 200mVp-p
IC2
$�
(TEO)
4
2.6Vp-p
DISPLAY board
MAIN board
7.6µsec
IC1
LOAD SW board SERVO board
3
(MDP)
5
5.8Vp-p 22.7µsec
IC1
@º
(LRCK)
6
5.7Vp-p 474nsec
Note on Schematic Diagram: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. Note: The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. � U : B+ Line. � H : adjustment for repair. � Power voltage is dc 14.4V and fed with regulated dc power supply from ACC and BATT cords. � Voltage and waveforms are dc with respect to ground under no-signal conditions. no mark : CD PLAY � : Impossible to measure � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances. � Circled numbers refer to waveforms. � Signal path. J : CD
