SONY CFD-E55
Instrukcja Obsługi

Waking up to music (continued)

6

Press TUNE TIME SET + or � to set the volume, then DSPL ENT MEM.

Tips � To exit the standby mode, press STANDBY to make cdisappear from the display. � The preset settings remain until you reset them. Note When you press N or z button of the tape player in the timer mode: If the tape length of one side is longer than the set time, the player will be turned off at the end of the tape, not at the set time.

7

Press STANDBY. The cindication lights up and the power goes off. At the preset time, the power will go on, and the music will play. Then the power will go off at the preset time, and the player will enter into the standby mode.

To check/change when the playback will start Press TIMER, then DSPL ENT MEM. Each time you press DSPL ENT MEM, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it.

To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 21, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. To stop play Press POWER to turn off the power.

22

The Timer