Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
6 Press M.
The character you selected in step 5 stops flashing and the cursor shifts to the right.
Erasing a disc title 1 Press MENU/NO on the remote in stop
mode.
7 Repeat steps 4 to 6 to complete the
entire title. If you made a mistake
2 Turn ./> (or press . or > on
the remote) until �Name Erase ?� appears, then press ENTER/YES on the remote.
Press m or M until the character you want to change flashes, then repeat steps 4 to 6.
To erase a character
3 Turn ./> (or press . or > on
the remote) to select the disc title you want to erase.
Press m or M until the cursor shifts to the character you want to erase, then press CLEAR on the remote while the character is flashing. You cannot insert characters.
The disc title appears scrolling in the display. �No Name� appears if no disc title is labeled.
4 Press ENTER/YES on the remote again.
�Complete!� appears. To erase all disc titles, turn ./> (or press . or > on the remote) until �All Erase?� appears in step 2, then press ENTER/ YES on the remote twice.
To cancel erasing
8 Press ENTER/YES on the remote to
complete the labeling procedure. To cancel labeling
Press MENU/NO on the remote during step 1 to 7.
Press MENU/NO on the remote during steps 1 to 3.
Note
Checking the disc titles 1 Press MENU/NO on the remote in stop
mode.
To ensure that disc titles are not erased from memory, have the system connected to wall outlet at least once a month.
2 Turn ./> (or press . or > on
the remote) until �Name Check ?� appears, then press ENTER/YES on the remote.
3 Turn ./> (or press . or > on
the remote) to select the disc titles stored in the system memory between 01 and 50. To check the current disc title
