...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
CH-X400/CH-X450
Removing the top cover
1. Pull out the dampers, being careful not to damage. When reattaching a damper, insert your finger to push out the center of the damper to mount it on the damper shaft, as shown in Fig. 6-1. 2. Turn the damper spring bracket toward the top at a right angle as shown in Fig. 7, then push down the lower side of the damper spring bracket to lift it off. 3. Remove the three fixing screws (3) and (4) on the DIN jack PCB assembly. 4. Lift the changer unit upward. 5. Remove the damper springs from the mechanism chassis if required. To reassemble, refer to the diagram below.
Fig. 5 Apply alcohol to the shaft then immediately attach the damper. (After attaching, check that the shaft is correctly inserted.)
Fig. 6-1
Push out with your finger before attaching
Lift the changer unit upward
Fig 6 Turn to the top position (at a right angle), then push down to lift off.
Fig. 8 Fig. 7 4 Remove the flexible ribbon wire if required Mechanism Chassis Silver (mechanism side) Red (magazine side) 4
How to attach the damper springs Fig. 8-1 Fig. 9 3
