jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
CH-X550
2.4.10 Removing the mechanism board / pickup assembly (See Fig.12 to 15) (1) Remove the three screws N fixing the mechanism board on the back of the traverse mechanism. (2) Disconnect the two feed motor wires (blue and white), two spindle motor wires (red and black) and two tray motor wires (brown and black) that are soldered to the mechanism board. (3) Short-circuit the grounding point on the mechanism board. Move the mechanism board without disconnecting the wire from connector CN501. Solder the short circuit round on the pickup assembly. (4) Disconnect the wire from connector CN501 on the mechanism board. (5) Remove the screw O to remove the feed motor assembly. (6) Remove the screw P to remove the shaft holder retaining the feed slide shaft assembly and the middle gear. (7) Move the middle gear. (8) Move the pickup assembly upward from the gear section and remove it from the traverse chassis assembly. (9) Remove the two screws Q to remove the rack arm. (10) Pull out the feed slide shaft assembly. CAUTION: To reattach the mechanism board, connect the pickup flexible wire to connector CN501 on the mechanism board before unsoldering the short circuit round. Subsequently, fix the mechanism board using screws. (11) Remove the screw R to remove the spring.
Pickup assembly
Grounding point
P
Shaft holder Feed slide shaft assembly Feed motor Middle gear
Chassis Remove gears and motors only when required.
Fig.14
O
R
Spring
Red and black
CN501 Brown and black
N N
Rack arm
Pull out
Q
Mechanism board Blue and white Fig.12 Flexible wire
