|
|
|
Kto jest w sklepie?
Sklep przegląda 5863 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
WALL MOUNTING SETTING THE SELECTORS
L to decrease ringer volume in the handset. you cannot use the page/find/intercom feature create a handset hook. from base unit to the handset. Notes: Even if the RINGER volume switch is OFF, you openings base unit, and attach hooks on each side Do not change position of the RINGER volof wall mount bracket into base unit. ume switch during a conversation, otherwise the
2 3 1 4 5 7 0
This unit can be mounted on a wall phone plate. Set the RINGER volume switch H to increase, or
1 1 Pull out hook, in direction indicated by arrow, When set to OFF, the handset does not ring, and
2 Insert hooks on upper part of wall mount bracket into 1 can make calls from the handset.
call will be disconnected.
6 9 8
Set the DIAL MODE switch to TONE if your phone
2
line has touch tone service. check with your local phone company. Mount unit on wall phone plate so that the heads of
3 Connect telephone line lead socket on wall If it has rotary service, set the switch to PULSE.
phone plate. If are not sure which service you have, please
3
studs of wall phone plate are inserted into the slots on Set the RINGER volume switch H to increase, or wall mount bracket. Then seat the base unit securely by pushing it down.
5 Even if the RINGER volume switch is OFF, a low 4 Slide the SPEAKER VOLUME control toward MAX
L to decrease ringer volume in the base unit. When set to OFF, the base unit does not ring. paging beep will be heard. increase, or toward MIN to decrease the sound level in the base unit. For best results, leave it set toward the middle position.
2 5 Extend aerial of the base unit fully and vertically 3 4
Note: When placing the handset on a wall mounted base, place it on base as shown in drawing. Do not place the handset with its keypad facing out when the base is mounted on the wall. for the best performance.
�5�
Install screws into the wall so that they are in a straight line vertically, spaced 83 mm (3-1/4") apart. Screw them in completely so there is about a 3
If you do have a plate or if the mount bracket does not match your wall phone plate, install it directly on a wall, as shown below, using screws included with the unit.
83 mm (3-1/4") mm (1/8") space between wall and the screw.
Wall surface
CL-D26X
Wall mounting
Approx. screw 3 mm (1/8")
|
|
|
> |
|
