Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
Installation Instructions 1 Important! The new applianceregisteredbe inmay only stalled and connected by a specialist. Please observe this instruction, otherwise the warranty will not cover any damage that may occur.
1 Safety Instructions for
the Installer
� A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors. � In respect of fire protection, this appliance corresponds to type Y (EN 60 335-2-6). Only this type of appliance may be installed with a high cupboard or wall on one side. � Drawers may not be fitted underneath the hob. � The installation must guarantee shock protection. � The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 68930. � For protection against moisture, all cut surfaces are to be sealed with a suitable sealant. � On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout. � On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. � Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing. � Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. � The hob must be pressed out from below when removed.
