SONY CPD200GST 2
Instrukcja Serwisowa

CPD-200GS

2-4. PICTURE TUBE REMOVAL
� Remove the D, A and J boards (Refer to 2-3.)
2 Neck assy

3 Deflection yoke 4 Four screws

(Tapping screw 5)

5 Picture tube shield

1 Anode cup

6 Picture tube

Cushion

� REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.

� REMOVING PROCEDURES
c

b a

Anode Button

1 Turn up one side of the rubber cap in the direction indicated by the arrow a.

2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.

� HOW TO HANDLE AN ANODE-CAP
1 Don�t hurt the surface of anode-caps with shartp shaped material! 2 Don�t press the rubber hardly not to hurt inside of anode-caps! A material fitting called as shatter-hook terminal is built in the rubber. 3 Don�t turn the foot of rubber over hardly! The shatter-hook terminal will stick out or hurt the rubber.

3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling up it in the direction of the arrow c.

2-2