SONY CPDG220S
Instrukcja Serwisowa

CPD-G220R/G220S

1-4. PICTURE TUBE REMOVAL

Place the unit face down on a cushion to avoid scratching. Remove the anode cap. Remove (4) screws (Screw (5) Tapping) from the CRT. Remove the picture tube shield. Remove the de�ection yoke. Remove the neck assembly.

7 8

Remove the A board. Remove the demagnetization coil. Remove (2) screws (BVTP 4 x 16) from the chassis assembly and slide out to remove.

ANODE CAP REMOVAL
WARNING: High voltage remains in the CRT even after the power is disconnected. To avoid electric shock, discharge CRT before attempting to remove the anode cap. After removing the anode cap, short circuit to either the metal chassis, CRT shield, or carbon painted on the CRT.

REMOVAL PROCEDURES

Turn up one side of the rubber cap inthe direction indicated by arrow a .

Use your thumb to pull the rubber cap �rmly in the direction indicated by arrow b .

When one side of the rubber cap separates from the anode button, the anode cap can be removed by turning the rubber cap and pulling it in the direction of arrow c .

HOW TO HANDLE AN ANODE CAP
1. 2. 3. Do not use sharp objects which may cause damage to the surface of the anode cap. To avoid damaging the anode cap, do not squeeze the rubber covering too hard. A material �tting called a shatter-hook terminalis built into the rubber. Do not force turn the foot of the rubber cover. This may cause the shatter-hook terminal to protrude and damage the rubber.

�7�