Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 31 (kliknij aby zobaczyć)
Wiring of the circuit power supply (2/2) Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 (3)Attach the power supply sheet. (4)Style the CNPWR.
TSW Fastener
Lock the CNPOW, TSW, and FG3 by passing them through the power supply case fastener.
Make sure to pass the CNSH2 through the hole indicated in the diagram below. [CAUTION] Make sure to attach the power supply sheet after attaching the CNSH2.
Power supply case
CNPOW
FB5
Pass the CNPWR through the hole in the power supply sheet, and pull the wire out. When pulling out the CNPWR and FB2, make sure that they do not pass over the C104 (electrolytic capacitor), as this will cover the anti-explosion valve on the top of the capacitor.
View from above
C104
CN102
FG3 Power supply sheet CN103 C104 FG1
FB1
CP-S240(CC9SM)/CP-X250(CC9XM)
Circuit power supply
CN101 FB2 CNSH2
E2
31
View from the side
C104
Fasten the CNSH2 and E2 with tape, ZTP1 and ZTP2, after passing them through the clamps of the power supply case. [CAUTION] As the upper case touches the gray areas of the diagram on the right, make sure no wires protrude into these areas.
CNPWR
ZTP2
Clamp Clamp
Power supply sheet
Power supply sheet
C104
C104
Correct (solid line) Correct Incorrect
Louver of the power supply case Incorrect (dotted line)
Outline of power supply case holes
Don�t wire the E2 on the louvers. The solid line in the diagram indicates an example of correct wiring. The dotted lines in the diagram indicate examples of incorrect wiring.
ZTP1
Fasten the E2 with tape ZTP1. Make sure to stick the tape along the outline of the power supply case holes as shown in the diagram.
