HITACHI CPS240WF
Instrukcja Serwisowa

Wiring of the circuit power supply (2/2) Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 (3)Attach the power supply sheet. (4)Style the CNPWR.
TSW Fastener

Lock the CNPOW, TSW, and FG3 by passing them through the power supply case fastener.

Make sure to pass the CNSH2 through the hole indicated in the diagram below. [CAUTION] Make sure to attach the power supply sheet after attaching the CNSH2.
Power supply case

CNPOW

FB5

Pass the CNPWR through the hole in the power supply sheet, and pull the wire out. When pulling out the CNPWR and FB2, make sure that they do not pass over the C104 (electrolytic capacitor), as this will cover the anti-explosion valve on the top of the capacitor.
View from above
C104

CN102

FG3 Power supply sheet CN103 C104 FG1
FB1

CP-S240(CC9SM)/CP-X250(CC9XM)

Circuit power supply

CN101 FB2 CNSH2

E2

31
View from the side

C104

Fasten the CNSH2 and E2 with tape, ZTP1 and ZTP2, after passing them through the clamps of the power supply case. [CAUTION] As the upper case touches the gray areas of the diagram on the right, make sure no wires protrude into these areas.

CNPWR

ZTP2
Clamp Clamp

Power supply sheet

Power supply sheet

C104

C104

Correct (solid line) Correct Incorrect

Louver of the power supply case Incorrect (dotted line)
Outline of power supply case holes

Don�t wire the E2 on the louvers. The solid line in the diagram indicates an example of correct wiring. The dotted lines in the diagram indicate examples of incorrect wiring.

ZTP1

Fasten the E2 with tape ZTP1. Make sure to stick the tape along the outline of the power supply case holes as shown in the diagram.

Wiring diagram 2