|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
SPEAKER STAND
OPERATING GUIDE
CP-ST3
BEFORE USE
Thank you for purchasing the CP-ST3 Pioneer speaker stand. This speaker stand should only be used for a Pioneer speaker system. ÷ Read this operating guide carefully before setting up your speaker system, and then save it for future reference. ÷ Before setting up your speaker system, a thorough reading of the operating guide is recommended.
Assembly
Tools required: A medium-size Phillips screwdriver and the supplied hexagonal wrench.
Note: Assemble the stand on a level surface, preferably covered with carpet. Follow the instructions below to assemble the stand. 1 Insert the tubular supports into the mount, and fix using the two M4x8 (3/16x5/16in) screws from the back of the supports. 2 Insert the tubular supports into the holes in the base. Use the hollow bolt to fix the left-hand support; the speaker cable passes through the hole in the bolt. Use the ordinary bolt to fix the right-hand support. Use the supplied hexagonal wrench to tighten the bolts. * Be careful to use the correct bolts for the left and right supports. M4x8 (3/16x5/16in), two fixing screw (BXZ40P080FZB)
CAUTIONS
÷ Fix the speaker system to the stand using the fixing screws supplied. ÷ Do not place the stand on an unstable and/or sloping surface. Otherwise, the stand and speaker may fall and cause injury. ÷ Do not mount any speaker other than the specified Pioneer speaker on this stand. Otherwise, the stand may collapse and/ or the speaker may fall and cause injury. ÷ When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding the tubular columns. ÷ This stand can hold a speaker with the maximum weight of 1.0 kg (2 lb 3oz).Mounting a speaker heavier than the maximum weight may cause the stand and speaker to collapse and be damaged.
Tubular supports
You can mount the HTZ-ST7 Pioneer satellite speaker on this stand.
Tubular supports
Names of Parts
( )The replacement part numbers are shown in parentheses.
Assembled CP-ST3 speaker stand
Tubular supports (SNK2365) Base Assy
Tubular supports (SLH1064) Ordinary hexagonal bolt (SBA1169)
Washers(WCX0FZB) Hollow hexagonal bolt (SBA1168) Supplied hexagonal wrench (SEX1020)
Base Assy
3. Insert the speaker cable (supplied with HTZ-ST7) into the bottom of the left-hand support and pass it through the support, until it appears at the mount end. 4. Pass the speaker cable through the mini-stand (supplied with HTZ-ST7), then fix the mini-stand to the mount using the doublesided adhesive tape and mounting screw M3x10 (1/8x3/8 in).
|
|
|
> |
|
