|
|
|
Kto jest w sklepie?
Sklep przegląda 6043 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
HT-DP2500W
(Continued)
s AM/FM Interval (span)
The International Telecommunication Union (ITU) has established that member countries should maintain either a 10 kHz or a 9 kHz interval between broadcasting frequencies of any AM station. The illustration shows the 9 kHz interval zones (regions 1 and 3), and the 10 kHz interval zone (region 2). This product is not equipped with a span selector. However, it will be adjusted to 9 kHz AM interval (50 kHz FM interval) when shipped from the factory. Before using the unit, be sure to set it for the AM tuning interval (span) used in your area. To check the tuning span currently selected:
1 2
ON/STAND-BY
Set the ON/STAND-BY button on the main unit to ON. Press the TUNER (BAND) button until "FM" or "AM" appears in the display. Press the TUNER (BAND) button to select the AM band.
3
q If "AM 531 kHz" is displayed, it means that the radio has been adjusted for a 9 kHz span. If "AM 530 kHz" is displayed, it means that the radio has been adjusted for a 10 kHz span. TUNER (BAND) ENTER To change from a 9 kHz AM (50 kHz FM) interval to a 10 kHz AM (100 kHz FM) interval:
1
ON/ STAND-BY
Press the ON/STAND-BY button on the remote control to enter the stand-by mode. Hold down the TUNER (BAND) button and the ENTER button for at least 4 seconds. Release the buttons when "AM SP 10 kHz" and "FM SP 100 kHz" are displayed alternately.
2
To return to a 9 kHz AM (50 kHz FM) interval:
1 2
[9 kHz � 10 kHz]
Press the ON/STAND-BY button on the remote control to enter the stand-by mode. Hold down the TUNER (BAND) button and the ENTER button for at least 4 seconds. Release the buttons when "AM SP 9 kHz" and "FM SP 50 kHz" are displayed alternately.
(4 seconds)
Caution: q When the unit is left for a few hours after the span has been switched and AC power lead disconnected, it will be automatically returned to a 9 kHz span. If this happens, set the span again. q When the span is switched, any stations that are memorised will be cancelled.
[10 kHz � 9 kHz]
(4 seconds)
�5�
|
|
|
> |
|
