Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
lights while receiving an FM stereo signal. Frequency Band Preset Number
Display change
Press [DISP] (Display) to change the display.
Radio mode display (Default)
Clock display
lights while receiving the D�M (Direct Memory) station.
Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Preset stations can be simply called up by pressing one of the preset buttons from [1] to [6].
Manual station preset
1 Tune into a station. 2 Hold down one of the preset buttons from
[1] to [6] for more than 2 seconds.
Auto Preset Memory (APM)
With this operation, stations with good receiving conditions can be automatically stored in the preset memory.
1 Select a band. 2 Hold down [BAND] (APM) for more than 2
seconds.
The preset stations under best receiving conditions are received for 5 seconds each after presetting the stations (SCAN). To stop scanning, press one of the preset buttons from [1] to [6]. Note: New stations overwrite existing saved stations.
(blinks once) Note: New stations overwrite existing saved stations.
Your favorite FM/AM radio station can be memorized in the [D·M] button and you can call back the radio station just by pressing the button whatever the current sound source is, even if the power is off.
D�M station writing
1 Select a station you would like to preset. 2 Hold down [D�M] for more than 2 seconds.
Direct Memory Station Preset Radio Mode Display
D�M station calling
1 Press [D�M] (Direct Memory).
Press again to cancel.
