jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 91 (kliknij aby zobaczyć)
CR200
8-6. Typical Faults on CD-R
1. Signal skipping or interruption
� There are scratches, dusts and / or fingerprints on the disc. � The pickup is faulty. � Misalignment (Screw, etc.).
2. Signal skipping or interruption occurs when the disc is recorded and then played back on the same CD-R unit.
� The recording power is too low. � The pickup is faulty. � Some of the section on the disc where dusts were attached could not be properly recorded.
3. SEARCH operation cannot be executed.
� AC voltage is too low (-15% or more). � The gear in the servo mechanism is faulty (scratches, etc.). � Misalignment (Screw, etc.). � The pickup is faulty.
4. The unit cannot be put into REC-PAUSE mode.
� The recording power is too low. � The pickup is faulty.
5. The tray cannot be open.
� There are scratches or dusts on the FG detection photo reflector pattern attached to the bottom side of disc table. � The wires inside the unit get entangled. � The oil put in the loading mechanism is too less.
