Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 23 (kliknij aby zobaczyć)
MAINTENANCE Adjusting the Oven Thermostat
After using your oven the first few times, it may seem hotter or cooler than your previous oven. Oven thermostats, over a period of years, may drift from the factory setting and timing differences of 5 to 10 minutes are not unusual between an old and a new oven. You may be inclined to think that the new oven is not performing correctly; however, your new oven has been set correctly at the factory and is more likely to be accurate than the oven it replaced.
Leveling Legs
Some floors are not level. For proper baking, your range must be level. The leveling legs are located on each corner of the base of the range. Place a level horizontally check front-to-back and turning the legs. on an oven side-to-side. rack and Level by
you can adjust it yourself. To decide how much to change the thermostat, set the oven temperature 25°F higher or lower than the temperature in your recipe, then bake. The results of the "test" should give you an idea of how much the thermostat If you be should thinkchanged. oven should be hotter or cooler, the To adjust the thermostat: oven
_
"_ J/
1. Press the OVEN TEMP pad. 2. Press the � or � pad and select an temperature between 500°F and 550°F.
3. Press and hold the OVEN TEMP pad for about four seconds. The display will change to the oven adjustment display which reads 00 °. 4. The oven thermostat can be adjusted up to +35°F hotter or -35°F cooler. Use the � or � pad to select the desired change in the display. 5. When you have made the adjustment, press CANCELpadtoreturntothetimeofdaydisplay. Use your oven as you would normally,
Fuses
the
(Canadian
Ranges
Only)
Your range is equipped with seven (7) type "P" fuses. The fuses are located on the back wall. Remove the storage drawer for access to the fuses.
LOCATION OF 7 FUSES _
//
If part of your range does not operate, check to see if a fuse has blown. A gap in the fuse strip or a darkened window indicates a blown fuse. Replace with the same type and amperage "P" fuse.
