WHIRLPOOL CRE9600CGE
Instrukcja Obsługi

4. Wipe up acid spillovers such as lemon juice, tomato sauce or milk-based sauces and sugary Porcelain enamel is acid resistant, not The poreelaln finish may dlseolor if are not wiped up prior to a self-dean spillovers. acid proof, acid spills cycle.

To Interrupt

or Reset

the

Clean

Cycle

If tile door has not locked, tile lock lever can be moved completely to the left to cancel the cycle. If the door is locked, push the CANCEL pad. The door will not open until "Lock" turns off in the display. At that time, the door lock lever can be returned to its original position and the door can be opened. The oven will still be hot. After the Self-Clean Cycle

5. Do not use oven cleaners or oven liner protective coatings of any" kind on the self-clean oven tlnish or around any part of the oven as they will damage the oven finish, 6. To prevent damage, do not clean or rub tile gasket on tile oven door. The gasket is designed to seal in heat during the clean cycle. 7. Turn off the oven light before starting the self-clean operation. If the oven light is left on during the clean cycle, the light bulb will burn out. Setting the Controls for the Self-Clean

About one hour after the clean cycle is complete, the word "Lock" will turn off in the display and the door lever can be returned to its original position. The oven will still be hot. Some soil may leave a light gray, powdery ash which can be removed with a damp cloth. If soil remains, it indicates that the clean cycle was not long enough or a large spillover was not wiped up before the self-clean cycle. The soil should be removed during the next clean cycle. If the oven racks were left in the oven during the selfclean cycle and do not slide smoothly, wipe the rack edges and rack supports with a small amount of vegetable oil to restore the ease of movement. Fine hair-like lines may appear in the oven interior or oven door. This is a normal condition resulting from the heating and cooling of the porcelain finish. These lines do not affect the performance of the oven.

Cycle i. Close the oven door and move the door lock lever to the right until it rests in the lock position, 2. Press the SELF CLEAN pad. The words "Set Clean Time" will flash and "3:00" will appear in the display, Also,"Clean On" will light as the ovenbegins to heat. The oven will automatically set a clean cycle of three hours. A shorter (2 hours) or longer (4 hours) clean cycle can be selected by pressing the SELF CLEAN pad and pressing the � or � pad to select 2 to 4 hours, 3. Press the CLOCK pad and the current time of day will reappear in the display. "Clean" and "On" will remain in the displav to show that tile oven is in a clean cycle. If the door is not locked properly, the word "door" will appear in the display and beeps will sound.

PAGE 13