...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 27 (kliknij aby zobaczyć)
Message
Solution
Error No.
28
Error Description
During the CGMS picture (possible a record once) input. (Disc which there is not for the correspondence to VR Format CPRM) Disc Protected Disc. There is no it in a space field. It is recorded a 99 title. (Video Format Disc) It is recorded a 99 title. (VR Format Disc) There is 999 number of total chapter. (VR Format Disc) There is not a space to a record field of control information. PCA Full. (in REC start) It is done Finalize. (Video Format Disc) Access to Memory Area range outside. Sector Address is wrong. BUP writing error of chapter editing.
Priority
12
This program is not allowed to Insert a ver.1.1 CPRM be recorded on this disc. compatible DVD-RW disc. This disc is protected and not recordable. Disc is full. (No area for new recording) You cannot record more than 99 titles on one disc. (The maximum is 99.) You cannot record more than 999 chapters on one disc. (The maximum is 999.) Release the disc protect setting in the Disc Setting menu. Insert the recordable disc with enough recording space. Delete unnecessary titles.
29 30 31 32
7 5 7 8 9 10
Delete unnecessary chapter markers.
33 34
You cannot record on this disc Delete unnecessary titles. as Control Information is full. You cannot record on the disc as Power Calibration Area is full. This disc is already finalized. Insert a new disc. Release the finalizing for this disc. Repeat the same operation.
35 36 37
4 6 -
Can not record on this disc.
38 39
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error messages (error number: 1 to 39) is displayed on the recording menu after timer recording. (Once the timer programming list with error indication is displayed, the program line(s) with error will be cleared only after the programs are cancelled and reset to the timer standby mode.) (In the case of the error occurs during setting the timer programming, no error messages is displayed.)
Timer Programming
Date Start End CH
VCR DVD
DVD VCR
Speed
*
2. 3. 4. 5. 6. 7. 8.
JAN/01 ---------------
12:57AM
1:57AM 8
DVD
E40
The speed mode changes to the error number.
A program with the error number is grayed out and asterisked on the timer programming list.
Message
Solution
- Set the timer programming correctly. - Set the timer programming before the start time. - Insert a recordable videotape with a record tab. Turn the power on and set the clock correctly then set timer programming again. Insert the recordable disc.
Error No.
Error Description
- Some portion has not been recorded because of program overlapping.
Priority
40
- Recording did not start at the start time. - No Videotape is inserted. Videotape ran out during recording.
