AIWA CX-LEM400
Instrukcja Serwisowa

CX-LEM400

ADJUSTMENTS BEFORE OPERATION
POWER 6STANDBY/ON ECO ECD, TUNER/ BAND, cTAPE, AUX f,g POWER CLOCK ENTER ECD, TUNER/ BAND, dTAPE, AUX SHIFT DIMMER f,g

Setting the clock
1 In stop mode, hold down SHIFT and press CLOCK on the remote.
Go to step 3 when the hour of the clock display flashes.

2 Within 6 seconds, press ENTER.
The hour flashes in the display.

3 Press f or g to set the hour, then press ENTER. 4 Press f or g to set the minute.
Each press changes the time in 1-minute steps. 5 Press ENTER. The time display stops flashing and the clock starts from 00 seconds. To display the time while the power is on Hold down SHIFT and press CLOCK on the remote. The time will be displayed for 6 seconds. If "- -:- -" appears when the unit is turned off There has been a power interruption. Reset the clock.

Turning the unit on Press POWER 6STANDBY/ON (POWER on the remote ). Alternatively, press cTAPE, TUNER/BAND, AUX or ECD. Playback will start automatically if a disc or tape is loaded. Turning the unit off Press POWER 6STANDBY/ON again. The unit goes into standby.

Power

Reduces power consumption in standby mode with the following operations.
Press ECO. Each press of the button changes the mode as follows;
ECO ON: Power economizing mode is activated. When the unit turns off, everything in the display disappears and only the red indicator on POWER lights to show that the power is being supplied. ECO OFF: Power economizing mode is cancelled. When the unit turns off, the clock display appears. Initial mode is ECO OFF. Standby power consumption ECO ON: 0.2 W ECO OFF: 9 W

ECO mode

Dimmer
The display window brightness can be selected.
Press DIMMER on the remote repeatedly. Each press of the button changes the following three levels: "DIMMER 1 ", "DIMMER 2" and "DIMMER 0 ". "DIMMER 0 " is the brightest.

6