|
Dla tego produktu nie napisano jeszcze recenzji!
RECORDING FROM A CD
Preparation � Wind up to the point where recording will start. q Use normal (type I) or CrOz (type II) tapes.
1 Insert the tape to be recorded on into deck 2.
Press the EJECT A mark to open the cassette holder. Insert the tape with the side to be recorded on first facing you and the exposed side down. 2 Set DOLBY NR. To record with DOLBY NR: Press the DOLBY NR button to turn on the Dolby NR. The 00 NR indicator will light. To record without DOLBY NR: Press the DOLBY NR button to turn off the Dolby NR. The UU NR indicator will go off. 3 Set the reverse mode. Each time the REV MODE button is pressed, the reverse mode changes. To record on one side only, turn on z. To record on both sides, turn on =>. 4
1
Press the CD button.
5 Load discs onto the disc trays. The disc loaded on tray 1 is played first. 6 Press the q REC/REC MUTE button to start record-
ing.
Playing and recording start simultaneously with the first track of the first disc. All discs in the compartment are recorded if the tape is long enough. When you use the remote control to start recording, first press the q/0 REC/REC MUTE button and then press the + F button within 2 seconds. To stop recording from the CD Press the s button to stop the deck, and press it again to stop the CD player. After play stops at the end of the CD Deck 2 enters recording stop mode. To record selected tracks Before pressing the q REC/REC MUTE button, program the tracks. (See �PROGRAMMED PLAY.) To record part of the CD When the q REC/REC MUTE buttonis pressed, recordingalways starts from the first track. To start in the middle of a track, play the CD uptothe point where you want to start recording, and then press the q REC/REC MUTE button.
6
RECIREC MUTE
~
52
|
