SONY D2846
Instrukcja Serwisowa

D2846

2-9. PICTURE TUBE REMOVAL
1

Open the D block (Refer 2-2.)

6

Four screws (+ BVTT 4 x 8)

4

Three connectors GND (DY) 6P (DY) 10P (DY)
3

A board

5

Anode cap

2 8 9

Neck assy

Open the G block (Refer 2-3.)

Deflection yoke

7

Picture tube

� REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.

� REMOVING PROCEDURES
c

b
a

Anode Button

1 Turn up one side of the rubber cap in the direction indicated by the arrow a.

2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.

� HOW TO HANDLE AN ANODE-CAP
1 Don�t hurt the surface of anode-caps with shartp shaped material! 2 Don�t press the rubber hardly not to hurt inside of anode-caps! A material fitting called as shatter-hook terminal is built in the rubber. 3 Don�t turn the foot of rubber over hardly! The shatter-hook terminal will stick out or hurt the rubber.

3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling up it in the direction of the arrow c.

� 17 �