Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
Maintenance and cleaning
General cleaning
Inspect the �lters and spray arm nozzle before re-loading the dishwasher and remove any food scraps. Wipe round the rubber gasket at the bottom of the door to remove grease which tends to collect there.
Moving the dishwasher
If you have to move the dishwasher (you are moving house, etc): 1. Unplug it. 2. Turn off the water tap. 3. Remove the water inlet and discharge hoses. Avoid tilting the dishwasher during transportation.
Cleaning the �lters
There are two �lters, a coarse one and a �ne one which should be cleaned after every wash. Lift out these �lters which are in the base of the dishwasher and wash under running water. The dishwasher must not be used without the �lters. Incorrect repositioning of the �lters will produce poor washing results. Cleaning of the �lters is vital to ensure correct operation of the dishwasher.
Protecting the dishwasher against freezing
If the dishwasher is placed in an environment where the temperature sometimes fall below 0° C, there is a risk that the small amount of water which remains inside the parts of the dishwasher will freeze and damage it. To prevent this you should: 1. Turn off the water supply to the dishwasher. 2. Remove the water inlet and discharge hoses. 3. Make sure that there is dishwasher salt in the salt container for the water softener. The appliance is only to be used and stored indoors at normal room temperature. The manufacture is not responsible for any frost damage.
Cleaning the spray arm nozzle
The holes in the spray arm nozzle must be kept free of scraps for the ef�ciency of the washing action. Inspect the spray arm regularly. When thorough cleaning is necessary, remove the spray arm by unscrewing the nut anti-clockwise, remove the washer and lift off the spray arm. Wash the spray arm with hot soapy water using a stiff saucepan brush if necessary to remove scraps. Re-assemble carefully, making sure the nut is secure.
Cleaning the cabinet
Wipe the outside of the cabinet and control panel regularly with a soft damp cloth. When necessary, use washing up liquid to remove stubborn marks, rinse with a damp cloth and rub up with a soft duster. Never use abrasive cleaners which could damage the surface, ie: scouring pads or solvents (acetone, trichloriethylene, etc). If the dishwasher is not going to be used for some time, take the following precautions: 1. Unplug the dishwasher and turn off the water supply. 2. Fill up the rinse aid container. 3. Make sure the tub is clean by carrying out a wash programme (without any crockery) using Finish Dishwasher cleaner, then dry the inside thoroughly. 4. Leave the door ajar.
