|
|
|
Kto jest w sklepie?
Sklep przegląda 5481 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
DV MECHANICAL ADJUSTMENT MANUAL VII
3-25. Coaster (S) Block Assy and Coaster (T) Block Assy
1.
1)
Removal procedure
Remove the coaster (T) block assy 1 from the coaster (T) block shaft. Remove the coaster (T) block assy from the right groove of the drum base. Remove the coaster (S) block assy 2 from the coaster (S) block shaft. Remove the coaster (S) block assy from the left groove of the drum base. Remove coaster (S) assy 3 by rotating it through the key hole of GL (S) assy 4.
2.
1) 2)
Attachment procedure
Install the coaster (S) assy 3 into the key hole of the GL (S) assy 4 by rotating it. Insert the coaster (S) block assy 2 into the coaster (S) block shaft. While aligning it with the left groove of the drum base, push it in the way that the V-groove comes to the top until it reaches the pressure-bearing S. Push in the coaster (T) block assy 1 along with the right groove of the drum base. Align the phase of the GL gear S, GL gear T and the GL drive arm at the three phasing locations. Then install the coaster (T) block assy 1 in the coaster (T) block assy shaft.
2)
3)
3)
Key Points in Re-assembling
� When aligning the coaster (S) assy with the left groove of the drum base, the V-groove must come to the top. � TG4 and TG5 must not have any stain and their arms must not be deformed.
2 Coaster (S) block assy 4 Keyhole of GL (S) assy
Phase Adjustment Key Points in Re-assembling
When re-assembling, adjust the gear phase at the three positions. GL gear (S) GL gear (T)
V-groove must come to the top.
3 Coaster (S) assy
1 Coaster (T) block assy
Coaster (S) shaft
Pressurebearing S V groove The second tooth from the left
GL driving arm Drum base groove GL gear (T) � mark
GL gear (S) GL gear (T) shaft GL driving arm
The second tooth from the left GL driving arm
� The second tooth from the left of the GL gear (S) and the V-groove of the GL gear (T) must be in phase. � The second tooth from the left of the GL drive arm and the v mark must be in phase.
� 36 �
|
|
|
> |
|
