SONY DCR-PC100
Instrukcja Serwisowa

(Original : Page 18)

Note :Regarding the text with underline, refer to the original manual (D mechanism).

3-13. T HARD BRAKE, L BRAKE, S BRAKE ARM, S HARD AND CC SWITCH COVER 1. Removing 1) Refer to 1-1. to lift the cassette compartment assembly. 2) Remove the CC switch cover. Note: Take note of two clawsA and B. 3) Refer to 3-10. to remove the LED base assembly. 4) Remove the tension spring1 from the side of LS chassis, then remove the S brake arm, torsion spring and S hard. 5) Remove the tension spring 2 from the side of L brake, remove the T hard brake together with the tension spring 2. 6) Remove the L brake. 2. Attaching 1) Attach the S hard and torsion spring to the S brake arm. Note: Pay attention to attach the spring and S hard, and the hooking position of spring. 2) Hook the tension spring1 to the S brake arm, then attach the S brake arm to the LS chassis. Note: Pay attention to direction appoint at spring hook. 3) Hook the tension spring1 to the side of LS chassis. 4) Attach the L brake. 5) Hook the tension spring2 to the T hard brake , then attach the T hard brake to the LS chassis with hooking the tension spring2 to the L brake. 6) Refer to 3-10. to attach the LED base assembly. 7) Attach the CC switch cover so that claws A and B are into holes A and B each. 8) Refer to 1-1. to attach the cassette compartment assembly.

Hooking the tension spring 1.
Tension spring

Hooking the torsion spring.
S brake arm S brake arm

Hooking the tension spring 2.
S brake arm L brake

S hard Torsion spring CC down switch

T hard brake Hole B T hard brake

Tension spring

Hole A

Claw B Claw A

CC switch cover LS chassis

_9_