SONY DCRTRV230
Instrukcja Serwisowa

5-3. Capstan Motor Azimuth Position Adjustment
1. Check Procedure
1) Insert the thickness gauge (Ref. No. J-16) of 0.75 mm between the protrusion of the mechanism chassis and the capstan motor, and check the azimuth position.

2. Adjustment Procedure
1) Loosen the capstan azimuth adjustment screw (SANG camera pan 2 M1.4 � 4.5), and insert the thickness gauge (0.75 mm)(Ref. No. J-16) between the protrusion of the mechanism chassis and the capstan motor. Slowly tighten the capstan azimuth adjustment screw until it slightly contacts the thickness gauge, and remove the thickness gauge.

2)

1 Capstan azimuth adjustment screw (SANG camera pan 2 M1.4 � 4.5)

Capstan motor

FP-300 flexible board

2 Thickness gauge t = 0.75 mm

Mechanism chassis

Protrusion of the mechanism chassis

Fig. 5-3.

� 35 �