SONY DCRTRV230E
Instrukcja Serwisowa

4-15. LS Guide Roller, Guide Lock Plate (T), Pinch Pusher Assembly, Eject Arm
1. Removal procedure
1) 2) 3) 4) 5) 6) 7) 8) 9) Remove the LS chassis block assembly. (Refer to 4-10.) Remove the LS guide roller 1. Remove the P pressure plate spring 2. Remove the HLW cut (0.98 � 3 � 0.25) 3. Remove the pitch pressure plate assembly 4 in the direction of the arrow A. Remove the relay gear 5. Remove the screw (camera pan2 M1.4 � 1.6) 6. Remove the guide lock plate (T) 7 in the direction of the arrow B. Remove the eject arm spring 8 and HLW cut (0.98 � 3 � 0.25) 9.
Note: Do not reuse the HLW cut.

2. Attachment procedure
1) 2) Attach the eject arm spring 8 to the eject arm 0. Hook one end of the eject arm spring 8 on the protrusion of the main chassis block assembly and attach the eject arm to the shaft. Attach the HLW cut (0.98 � 3 � 0.25) 9. Do not reuse the HLW cut. Attach the guide lock plate T 7 while aligning it with the notches C and D. Attach the screw (camera pan2 M1.4 � 1.6) 6. Tightening torque: 0.078 ± 0.01 N�m (0.8 ± 0.1 kgf�cm) Attach the relay gear 5. Attach the pinch pusher plate 4 with the HLW cut (0.98 � 3 � 0.25) 3. Attach the P pressure plate spring 2. Insert the concave side of the LS guide roller 1 into the shaft to attach the LS guide roller.
Note: Insert the roller completely.

3) 4) 5) 6) 7) 8)

10) Remove the eject arm 0.

9)

Attach the LS chassis block assembly to the mechanical chassis. (Refer to 4-10.)

Notch D Notch C

6 Screw (camera pan 2 main M1.4 � 1.6) 7 Remove the guide lock plate (T) in the direction of the arrow B. B

Coat inside with grease too.
3 HLW cut (0.98 � 3 � 0.25) 4 Remove the pinch pressure plate assembly in the direction of the arrow A.

Pinch the rotary switch.
9 HLW cut (Do not reuse) (0.98 � 3 � 0.25) 0 Eject arm A 5 Relay gear

8 Eject arm spring

Concave side Coat inside with grease too.
2 P pressure plate spring 1 LS guide roller

When attaching it, coat the hatched portion with grease.

Fig. 4-15.

� 28 �