...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 22 (kliknij aby zobaczyć)
Tray (3)
� After inserting the tray (3), confirm that the mark of the gear (4) matches with that of the rack gear on the tray (first tooth of the gear). (Refer to Fig. B.)
B Gear (4) Tray panel (4) A
Figure A Triangle mark
Tray (3)
Claws
Tray panel (4)
Position of the line Pickup mechanism assembly Gear (4) The first tooth of the gear of this side on the tray rack gear.
Fig. 2-1-5 1-1-4. Front Panel and Tray 1. Remove the flexible cable (1). 2. Release four claws and remove the front panel (2). 3. Pull out the tray (3) to this side.
Rack gear Gear (4) Slider Tray (3)
Claw Tray (3) Marking Figure B
Fig. 2-1-7 1-1-5. Rear Panel 1. Remove three screws (1) and remove the rear panel (2).
Flexible cable (1) Screw (1) Front panel (2) Claw
Claws
Fig. 2-1-6 Note: � Insert the tray (3) with the front side of the pickup mechanism assembly descended. (The slider positions to the left side.) � The gears are required to match their phases each other. After setting the gear (4) as shown in the figure �A�, insert the tray (3). When inserting a tray (3), push the rack gear side shown by the arrow.
Rear panel (2)
