fastening the pins (10a) to the sides of the fastening screws (10b). Block the sides 10a sliding the two tabs outwards (11). Make electrical connection (12), but 10b leave the hood Fig. 10 disconnected from the home mains circuit. In the case that it is decided to use the cooker hood in the mains circuit, then place one of the two flanges provided in the exit hole (13 � Extraction). Attention! The tall flange should be used when a telescopic chimney is required to be mounted (this item should be ordered � see special accessories), the short flange is to be used in all other cases. Remount the grease filter and the front panels according to the numbering noted also on the back of each screen (from 1 to 4 from the top to 13 Extract. version the bottom). Connect the hood to the home mains circuit and check if the hood works properly.
12
