|
|
|
Kto jest w sklepie?
Sklep przegląda 5815 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Section
11
Audio Adjustments
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
�12� �6�Pass (0) (dB/oct.)
3 Turn MULTI-CONTROL to select Rear HPF FREQ. Rear HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the rear speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the rear speakers. Each time MULTI-CONTROL is pushed up or down, the level of the rear speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
3 Turn MULTI-CONTROL to select Front HPF FREQ. Front HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the front speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the front speakers. Each time MULTI-CONTROL is pushed up or down, the level of the front speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve created by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on page 56). You can turn the auto-equalizer on or off. 1 Use MULTI-CONTROL to select Auto EQ. Auto EQ appears in the display.
# Please set Auto EQ appears. This indicates that you cannot turn the auto-equalizer on if auto TA and EQ has not been carried out.
Setting the high pass filter for rear speakers
1 Use MULTI-CONTROL to select Rear HPF. Rear HPF appears in the display. 2 Push MULTI-CONTROL left or right to select slope. Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order: �12� �6�Pass (0) (dB/oct.)
2 Press MULTI-CONTROL to turn the autoequalizer on. ON appears in the display.
# To turn auto-equalizer off, press MULTI-CONTROL again.
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
52
En
|
|
|
> |
|
