Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
Replacing the fuse of the car battery cord
If the CD player does not operate, check the fuse. If it is blown, replace it as follows:
Notes on the car connecting pack
1 2 3 4 5
Turn off the CD player and remove the cigarette lighter plug from the cigarette lighter socket. Remove the plug end by turning it counterclockwise. Remove the defective fuse from the plug. Insert a new fuse into the plug. Replace the plug end by turning it clockwise.
� If no sound is heard or the car connecting pack is ejected, change the direction of playback on the car cassette deck. � Never insert the cord end of the car connecting pack into the cassette insertion door. Otherwise, the cord may break or the car cassette deck may be damaged. � You cannot use the car connecting pack with some car cassette deck. � The cord should be placed so that it does not hinder driving. � To disconnect the cord from the player, pull it out by grasping the plug. Never pull the plug out by the cord. � With some car cassette decks, you may hear some rattling noise from the car connecting pack. However, this is not a sign of malfunction.
Remove
Fuse
Plug end
Cigarette lighter plug
Notes
� Be sure to use a fuse of the same amperage and length as the one to be replaced. Never use a piece of wire as a substitute for the fuse. � If the fuse is blown again after replacing it, contact your nearest Sony dealer. In such a case, bring the defective fuse to the dealer with you.
