DENON DN-2600F
Instrukcja Obsługi

ENGLISH

2-2

Select the high frequency range to be filtered. Turn the data master knob (8�9). � If the data master knob (8�9) is pressed again, the player returns to the same status as in step 1-2. � The frequency can be set between 100 Hz and 20 kHz (or none). V The high frequency cannot be set below than the low frequency. NOTE: � For some tracks, clipping may occur in the playback sound. Start filtered playback. Press the ON/OFF button at any point between steps 1-1 and 2-2.

Start reverb playback. Press the ON/OFF button at any point between steps 1-1 and 2-2.

3
RVB ON RVB OFF
� When pressed again, reverb playback stops. Canceling the reverb data setting mode. Press the RVB/LOOP button. � The � � indicator is lit when the reverb mode is on. � The � off. � indicator is not lit when the reverb mode is

4

3

Using the flanger function
5 With this function you can create swelling sounds.

FIL ON

FIL OFF

� When pressed again, the filter turns off. Canceling the filter frequency input mode. Press the FIL/REVERSE button. � The � � indicator is lit when the filter is on. � The � � indicator is not lit when the filter is off. Set the flanger time input mode. Press the FLG/PITCH button.

4

1-1

***bpm 1/4

EFFECT
Flashing

Using the reverb function
5 With this function, an echo is produced at the set tempo. Set the reverb delay time input mode. Press the RVB/LOOP button.

1-2

Select the flanger time. Turn the data master knob (8�9). � The time can be set to 4/1, 2/1, 1/1, 3/4, 1/2, 1/4 or 1/8 the BPM set with the TAP (TAP/BPM) button. Set the flanger gain input mode. Press the data master knob (8�9).

1-1

***bpm 1/2

EFFECT
Flashing

2-1

L
Gain

Gain

H

Select the reverb delay time. Turn the data master knob (8�9).

1-2

***bpm 1/2
� The time can be set to 2/1, 1/1, 3/4, 1/2, 1/4 or 1/8 the BPM set with the TAP (TAP/BPM) button.

Select the flanger gain. Turn the data master knob (8�9).
PUSH ENTER

2-2
Set the reverb feedback number mode. Press the data master knob (8�9).

The gain increases when the knob is turned clockwise and decreases when the knob is turned counterclockwise.

2-1

L

F.Back

H

� If the data master knob (8�9) is pressed again, the player returns to the same status as in step 1-2. Start flanger playback. Press the ON/OFF button.

Feedback number

Select the reverb feedback number. Turn the data master knob (8�9).
PUSH ENTER

3

FLG ON

FLG OFF

� When pressed again, flanger playback stops. The feedback number increases when the knob is turned clockwise and decreases when the knob is turned counterclockwise. Canceling the flanger data setting mode. Press the FLG/PITCH button.

2-2

� If the data master knob (8�9) is pressed again, the player returns to the same status as in step 1-2.

4

� The � � The � off.

� indicator is lit when the flanger mode is on. � indicator is not lit when the flanger mode is

NOTE: � For some tracks, clipping may occur in the playback sound.

20