|
Kto jest w sklepie?
Sklep przegląda 5790 gości i 5 zarejestrowanych klientów
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
First Time Setup�Continued
7
Enter
After the 3rd or 7th measurement, the following screen appears.
Auto Speaker Setup Next finish(Calculate)
Review SP Distance: Review the speaker distance settings (see �Reviewing the Results� on page 58). Review SP Level: Review the speaker level settings (see �Reviewing the Results� on page 58). Cancel: Cancel the automatic speaker setup.
Enter
Please select �Next�, when measuring next position, and select �finish�, when ending.
Use the Up and Down [ ]/[ ] buttons to select an option, and then press [Enter]. Next: Select this if you want to measure another listening position. After the 8th measurement has been taken, the procedure automatically proceeds to step 8. Finish (Calculate): Select this if you don�t want to measure any more listening positions and are ready to calculate the results, then go to step 8.
10
If you selected �Save,� the results are saved, and the following screen appears.
Auto Speaker Setup
Saving...
11
Disconnect the setup microphone.
Auto Speaker Setup
8
When the measurements are complete, the following screen appears.
Auto Speaker Setup
Please unplug microphone.
Calculating...
9
Enter
When the calculations are complete, the following screen appears.
Auto Speaker Setup
Notes: � When the automatic speaker setup is complete, the Equalizer Settings (page 104) will be set to Audyssey. � You can cancel the automatic speaker setup at any point in the procedure simply by disconnecting the setup microphone.
Error Messages
Save Review SP Config Review SP Distance Review SP Level Cancel
Enter
During the automatic speaker setup, one of the following error messages may appear: � Ambient noise is too high
Auto Speaker Setup
Use the Up and Down [ ]/[ ] buttons to select an option, and then press [Enter]. Save: Save the calculated settings and exit the automatic speaker setup. Review SP Con�g: Review the speaker con�guration settings (see �Reviewing the Results� on page 58).
Retry Cancel
Ambient noise is too high.
This message appears if there�s too much background noise and the measurements cannot be performed properly. Remove the source of the noise and try again, or cancel the automatic speaker setup.
56
|
|
|
> |
|