INTEGRA DTM5.3
Instrukcja Obsługi

Remote controller

Using the remote controller
On Scan
Master Volume

Number buttons

RCVR/Tape

Standby/On

1 ABC

2 DEF

3 GHI

4 JKL

5 MNO

6 PQR

7 STU

8 VWX

9 YZ-

Standby
Direct Tuning 0/10 / Scan

Speakers
A B
Clear

Enter
Zone 2 Off Display Direct Tuning Memory FM Mode Character

Phones

DVD

Video

Tape 2 Monitor

Tape 1

FM

AM

Phono

CD

Bass

Treble

Balance

L

R

DTM-5.3

Standby/On

Memory

Setting the ID number
Programming the remote controller ID (This procedure is not required if you are using only one DTM-5.3.) If you are using multiple DTM-5.3 units, all units will respond to an operation on one of the remote controllers. To avoid this, you can establish up to nine ID numbers for the remote controllers. The same ID number should be set on both the remote controller and the corresponding DTM-5.3. You can use the remote controller as long as its ID matches that speci�ed on the main unit. To cancel the ID number, set the number to �0.� If the ID on the main unit is set to �0,� all remote controllers (with ID 0-9) can control the unit.

3 Turn on the power to the DTM-5.3, and press and hold down the Memory button.

The current ID number of the main unit appears on the display for �ve seconds.
DTM-5.3 (this unit)
Standby/On

Memory

Current ID

4 While the current ID of the unit appears on the display, press the On button on the remote controller.

Programming the ID number
1 On the remote controller, while pressing and holding down the RCVR/Tape button, press the Enter button, then release both buttons.
Remote controller

The remote controller will send its ID information to the unit, and the ID of the unit will be changed to match the remote controller�s ID.
Remote controller

2 Press one of the number buttons (1�9, 0).

For example, if you press �3� in Step 2: �UNIT ID 0� � �UNIT ID 3� The unit�s ID will change to �3.�

The number you pressed is set as the ID.
Remote controller

Hint:
You can use the number buttons on the main unit instead of pressing the On button on the remote controller. In this case, press the same number as the remote controller�s ID (selected in Step 2). E.g., Press �3.�

Checking the remote controller�s ID:
Press the Scan button on the remote controller while the display indication shown in Step 4 appears. The remote controller�s ID appears on the display. E.g., REMOTE ID 3

Note:
The unit will not respond to remote controller operations if the ID numbers do not match.

28