PHILIPS DTR4600/00
Instrukcja Obsługi

6

Day to Day operation
6.1 Switch your receiver
When you connect your receiver to mains the receiver front panel display gets on, after a few seconds the Welcome screen is shortly shown then after few tenth of seconds the receiver is either in standby or in viewing mode. Note: During power up after connection to mains, it is normal for the front display to turn off for few seconds. It shall turn on later on by showing MHP .

English
� �

6.2 Wake up or Switch your receiver to standby
You watch TV or listen to radio, press the standby button to switch your receiver to standby. Your receiver is in standby, to wake it up : - Either press the P+ or the P- button. - Or press one digit button.

6.3 Select TV or Radio mode
Your receiver may work in two modes: TV or radio. To switch between these two modes, press the RADIO key. If you are watching one of the TV channels, pressing RADIO tunes to the last tuned radio channel belonging to the previously selected channel list. Pressing RADIO again returns to the TV mode - to the last tuned TV channel. On switching the mode, the Channel Banner appears for its timeout. In the radio mode, the radio label appears/disappears at random positions on the screen to avoid damaging your TV screen.

Radio Label

6.4 How to switch between channel in the lists
Your receiver gives you access to TV Channel Lists and to Radio Channel Lists. To display the currently selected channel list, press the FAV key. Then select the channel by pressing V or W, or number keys. Each time you highlight a non-current channel, the [OK] icon appears in the Channel Banner. To tune to this channel, press OK.

TV Channel List

Note: Channels lists allow you to work in so-called browsing mode. In this mode, the box remains tuned to the same channel, while you browse through channels and programs.

10 DAY T O DAY O P E R AT I O N