INTEGRA DTR7.6
Instrukcja Obsługi

DTR-7.6,6.6.book Page 73 Monday, September 26, 2005 1:40 PM

Advanced Setup�Continued
Character Edit
With this setting, you can enter a custom name for each input source. When the input source is selected, its name will appear on the display.

5

Press the Down [ ] button to select �Character,� and then press the Right [ ] button to open the character input screen.
4-2.Character Edit ---------VIDEO1--------b.Character :������---+ |ABCDEFGHIJKLM| |NOPQRSTUVWXYZ| |abcdefghijklm| |nopqrstuvwxyz| |0123456789-.'| |()+*/=,:;!?_ | | [Exit]| +-------------+

1

Press the [Receiver] Remote Mode button, followed by the [Setup] button. The main menu appears onscreen.

2

Use the Up and Down [ ]/[ ] buttons to select �4. Input Setup,� and then press [Enter]. The Input Setup menu appears.
4.Input Setup ---------VIDEO1--------1.Delay 2.Character Edit

6

Use the arrow [ ]/[ ]/[ ]/[ ] buttons to select a character, and then press [Enter].

3

Use the Up and Down [ ]/[ ] buttons to select �Character Edit,� and then press [Enter]. The Character Edit menu appears.
4-2.Character Edit ---------VIDEO1--------a.Character Display :Yes b.Character : Press to Edit to Clear

7

Repeat step 6 to enter up to 10 characters. If you enter a character by mistake: Press the [Return] button to move the cursor back one place. To correct a character: 1. Press the [Enter] or [Return] button repeatedly to select the character to be corrected. 2. Use the Left and Right [ ]/[ ] buttons to select the new character, and then press [Enter]. If the name contains less than 10 characters, select �Exit,� and then press [Enter]. Press the [Setup] button. Setup closes.

4

Use the Up and Down [ ]/[ ] buttons to select �Character Display,� and use the Left and Right [ ]/[ ] buttons to select: No (Default): The default name is displayed. Yes: The custom name is displayed. This setting determines if the default name or the custom name you enter is displayed when the input source is selected.

8

To delete all the characters in a name: In step 5, press the Left [ ] button instead of the Right [ ] button. Notes: � When the multichannel input is selected, the same name as for DVD is displayed. � This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

73