Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 23 (kliknij aby zobaczyć)
1. Disconnect power supply to the
dishwasher. 2. Turn off water supply to the dishwasher. 3. Remove the 4 screws on the lower access panel and remove the lower access panel. 4. Place a shallow pan under the water supply valve. Then, use a wrench to disconnect the water inlet from the water supply valve. Separate the water inlet from the water supply valve and drain water into the pan. 5. Remove the spring clamp from the water outlet and separate from the water supply valve; drain water into pan. 6. Reconnect both water inlet and water outlet to the water supply valve.
Figure
1
Flgure 2
7. Empty the pan and reposition it under
the water pump. 8. Remove the clamp and disconnect the drain hose from the water pump; drain water into pan. 9. Reconnect drain hose to the water pump, being sure to position the clamp over the connection. 10. Replace the lower access panel. is connected to a garbage disposal, do not run water into the sink after winterizing. This could cause water to refill the drain hose on your dishwasher.
NOTE: If your dishwasher
Reconnecting
your
dishwasher
1. Remove the 4 screws on the lower
2. 3. 4. 5. access panel and remove lower access panel. Turn on the water supply to dishwasher. Turn on power supply to dishwasher. Run dishwasher through a complete cycle and check for leaks. Replace lower access panel.
Storing
for the summer
Protect your dishwasher during the summer months by turning off the water supply and power supply to the dishwasher.
