WHIRLPOOL DU9903XL0
Instrukcja Obsługi

When the HI-TEMP WASHING option is selected, water for the main wash and the final rinse is heated to 145°F (63°C) except in RINSE HOLD. Washing and rinsing action in parts of the cycle will be longer if the water is heated. The HOLD-HEAT WATER Signal Light will be on while water is heating. l Touch once to select the option. Touch again if you want to cancel it. l The Signal Light on the selectorwill be on if HITEMP WASHING is selected. l The Signal Light will be off if the option is not selected or if it can�t be used with the cycle selected; RINSE HOLD. l You can select or cancel the option during a cycle by touching the pad. l The HI-TEMP WASHING Option is not recommended in the CHINA CRYSTAL Cycle. When the HEAT DRY Selector is touched, air in the dishwasher is heated during the �dry� part of any cycle -except RINSE HOLD. If the signal light above the Dry Option Selector is ON, you will get HEAT DRY. If the signal light is OFF, you will get AIR DRY. The AIR DRY Option helps save energy, but dishes will take longerto dry (overnight) and some water spotting may result. Some items (such as plastics] may need towel drying. For best results, use a liquid rinse aid such as Jet-Dry.� You can select or cancel the option during a cycle by touching the option selector.

l

l

l

Load door. Select cycle and option or options desired. Touch the START DELAY WASH Selector once for each hour you want the dishwasher to delay. Do not touch START. The selected cycle will start automatically after the time in the Display has elapsed. You may touch START at any time during the delay if you want the dishwasher to start immediately Add time during the delay by touching the selector once for every additional hour of delay you want. Add items to the load at any time during the delay. Close and latch the door.

Use the DELAY WASH Option when you want the selected cycle to start later from 1 to 9 hours after loading the dishwasher. For example, use DELAY WASH to run the dishwasher during off-peak hours of electrical use. the dishwasher; close and latch the

Touch the DRAIN OFF Selector once to stop a cycle. The dishwasher will stop and the water will pump out. This takes about 2 minutes -the Display will show �02:� When the draining stops, a new cycle can be selected. Check the detergent dispenser before starting another cycle. Touch the selector twice to cancel DELAY WASH if you want to cancel delay hours but not start the machine immediately. If you cancel instructions during a cycle,the dishwasher will stop, but wafer will not drain away. Do not allow water to stand in the dishwasher. 9