Do hand-clean 1 1/2 inches from rack guides to front of oven cavity. Do not hand-clean the gasket.
Do hand-clean frame area outside the gasket.
Do hand-clean door area outside the gasket.
Figure 21: Cleaning Guidelines
4. Review illustration above. Some areas of the oven must be cleaned by hand before the cycle begins. Use a soapy sponge or plastic scrubber or a detergent-filled S.O.S.® pad. Hand-clean the oven door edge, oven front frame and up to 1-1/2 inches inside the frame with detergent and hot water. Do not clean or rub the gasket on the oven. The gasket is designed to hold in heat during the self-clean cycle. Rinse all areas thoroughly then dry. 5. Be sure oven light is turned off and the light bulbs and lens covers are in place. Do not operate oven without light bulb and cover in place. Important: Do not use Commercial Oven Cleaners on the self-clean oven or any part because they will damage the finish or part. Setting the Self-Clean Mode 1. Press COOKING MODE. 2. Turn knob until SELF CLEAN mode appears. Press START. 3. The default cleaning time is 4 hours. To change cleaning time, turn knob to change SELF CLEAN number of hours. Otherwise, continue to 3: 00 step 4. 3 4. Press START. SELF CLEAN flashes. Press START. 5. REMOVE RACKS appears in the display as a reminder to remove oven SELF CLEAN racks. 4: 00 6. Press START again to begin the selfclean.
REMOVE RACKS
Note: The door locks at the beginning of the cycle; The door lock symbol will appear in the display at this point. If door does not lock, press OFF and do not self-clean; phone service. Delaying the Start of the Self-Clean Note: The time of day must be correctly set for this option to work properly. See section �Setting the Clock� in �Getting Started�. 1. Press COOKING MODE. 2. Turn knob until SELF CLEAN mode appears. Press START. 3. The default cleaning time is 4 hours. To change cleaning time, turn knob to change number of hours. Otherwise, continue to step 4. English 44
