Getting Started
Step 1: Inserting batteries into the Remote Control
3 1 2
Step 2:
Setting up the TV
E n g l i s h
IMPORTANT! Make sure you have completed all the necessary connections. (See page 6-7 �Connecting TV�).
1 Turn on the TV and set to the correct
video-in channel. You should see the DVD background screen on the TV.
1 Open the battery compartment. 2 Insert two batteries type R06 or AA,
following the indications (+-) inside the compartment.
2 Usually these channels are between the
lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details. � Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. � Or, the TV Remote Control may have a button or switch that chooses different video modes. � Or, set the TV to channel 3 or 4 if you are using an RF modulator.
3 Close the cover.
Using the Remote Control to operate the Player
1 Aim the Remote Control
directly at the remote sensor (iR) on the front panel.
IR
3 If you are using external equipment, (eg.
audio system or receiver), turn it on and select the appropriate input source for the DVD Player output. Refer to the equipment owner�s manual for detail. To deactivate Progressive manually G When the distorted picture still appears on the TV, it may be due to the connected TV does not accept progressive signals, and progressive is set by mistake. You must reset the unit to interlace format.
2 Do not put any objects
between the Remote Control and the DVD Player while operating the DVD Player.
PREVIEW DIM SLEEP
MUTE
CAUTION! � Remove batteries if they are exhausted or if the Remote Control is not being used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed properly.
SOUND SURROUND
1 Turn off your TV progressive scan mode
or turn on to interlaced mode (refer to your TV user manual.)
2 Press OPEN/CLOSE on the DVD player
to open the disc tray.
3 Press numeric keypad �1� on the
remote control for few seconds. � The DVD blue background screen will appear on the TV.
